National Stock Number (NSN) 5330-01-085-9950, or NIIN 010859950, (seal,nonmetallic special shaped) was assigned November 20, 1979 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There is only one manufacturer part number associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 3 suppliers. Today, 3 suppliers are listed as Active suppliers for this NSN. Of the active suppliers, 3 suppliers are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over a year. There have been 2 contracts issued for this part number, with 2 awards given. There is minimal competition for this NSN. The US Government has awarded contracts to 2 different suppliers. The last contract numbers awarded were: SPE7L321P0493, SPE7L321P0493, SPE5E420V6462, SPE5E420V6462. The total value of the awarded contracts has been US$ 41,944.00.
This NSN is somewhat common among different platforms, belonging to 4 different weapons systems.
There has been a small amount of demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Dec 13, 2008, this NSN's acquisition method was noted as: Suitable for Competitive Acquisition. (Potential sources shall include dealers/distributors.) The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 32847. [AN ITEM FABRICATED FROM NONMETALLIC SPECIAL SHAPED SECTION. IT MAY BE (1) FORMED TO A SPECIFIC SHAPE WITH OR WITHOUT JOINTS, (2) A SINGLE PIECE WHOSE ENDS HAVE BEEN SECURED TOGETHER TO FORM A SPECIFIC SHAPE, OR (3) A STRAIGHT ITEM FABRICATED TO A SPECIFIC LENGTH FOR A SPECIFIC APPLICATION WITH END CUTS OR JOINTS. ITEMS, EXCEPT FOR MOLDED CORNERS, SLOT(S), PRESS FIT BUTTONS, AND THE LIKE MUST BE OF ONE CONTINUOUS CROSS SECTION. IT IS SPECIFICALLY DESIGNED FOR USE IN APPLICATIONS WHERE THERE IS NO RELATIVE MOTION BETWEEN JOINED PARTS. EXCLUDES:BUSHING, NONMETALLIC; PACKING, PERFORMED; PAD, CUSHIONING;AND SEAL, PLAIN. FOR STRAIGHT ITEMS WITH SQUARE END CUTS AND WITHOUT MOUNTING HOLE(S), SLOT(S), OR PRESS FIT BUTTONS, SEE NONMETALLIC SPECIAL SHAPED SECTION.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5330010859950 does not contain precious metals.
This NSN is associated to Schedule B 3926904500: gaskets,washers & other seals. The Schedule B End Use is listed as other industrial supplies. NAICS classification category 339991: gasket, packing, and sealing device manufacturing.
This information was last updated on Dec 01, 2024.