National Stock Number
5365-15-068-2734
National Stock Number (NSN) 5365-15-068-2734, or NIIN 150682734, (spacer,plate) has an unknown assigned date. This NSN does not replace any other NSNs.
There are 3 manufacturer part numbers associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 3 suppliers. Today, 2 suppliers are listed as Active suppliers for this NSN. Of the active suppliers, there are no suppliers that are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over a year. There have been 6 contracts issued for this part number, with 6 awards given. There is minimal competition for this NSN. The US Government has awarded contracts to 2 different suppliers. The last contract numbers awarded were: SPE4A722P8650, SPE4A022P0440, SPE4A619P8574, SPE4A419V3122, SPE4A619V4284. The total value of the awarded contracts has been US$ 15,566.11.
This NSN is somewhat common among different platforms, belonging to 3 different weapons systems.
There has been a small amount of demand for this national stock number. The demand for this NSN originated from less than 5 countries.
This NSN is assigned to Item Name Code (INC) 26979. [A FLAT METAL OR PLASTIC ITEM OF VARIOUS PERIPHERAL SHAPES HAVING A SOLID (NOT LAMINATED) CROSS-SECTION. IT IS DESIGNED TO MAINTAIN A PREDETERMINED DISTANCE BETWEEN TWO SURFACES. FOR ROUND ITEMS WITHOUT A HOLE HAVING A SOLID RECTANGULAR CROSS-SECTION USE DISK, SOLID, PLAIN. FOR ROUND OR HEXAGONAL ITEMS WITH ONLY ONE HOLE CENTRALLY LOCATED AND WITH THE LENGTH (THICKNESS) EXCEEDING 25 PERCENT OF THE OUTSIDE DIAMETER OR DISTANCE ACROSS PERIPHERAL FLATS, SEE SPACER, SLEEVE. THE THICKNESS BETWEEN THE TWO PARALLEL BEARING SURFACES MUST BE 0.006 INCH, (0.152 MM) OR MORE FOR ITEMS LESS THAN 1/4 INCH (6.35 MM) ACROSS THE PERIPHERAL DIAMETER, OR SMALLEST OVERALL OUTSIDE DIMENSION, OR MUST BE 0.016 INCH (0.406 MM) OR MORE FOR ITEMS 1/4 INCH (6.35 MM) OR GREATER ACROSS THE PERIPHERAL DIAMETER OR SMALLEST OVERALL OUTSIDE DIMENSION. FOR ITEMS WITH A THICKNESS LESS THAN THOSE INDICATED ABOVE, SEE SHIM. FOR ITEMS WITH ONE HOLE CENTRALLY LOCATED CONFORMING TO THE ABOVE DIMENSIONAL CRITERIA USE WASHER, FLAT OR SPACER, RING AS APPLICABLE. WHEN THICKNESS AND/OR OUTSIDE_DIAMETER_OR_SMALLEST_OVERALL_OUTSIDE_DIMENSION_IS_DESIGNATED_AS_A_TOLERANCE/DIMENSION_THE_MAXIMUM_DIMENSION_WILL_BE_USED_TO_DETERMINE_COMPLIANCE._EXCLUDES:GASKET;_INSULATOR_(AS_MODIFIED)_AND_MOUNTING_PAD,_ELECTRICAL-ELECTRONIC_COMPONENT.____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________].
This information was last updated on Dec 23, 2024.