National Stock Number
5999-01-068-1030
National Stock Number (NSN) 5999-01-068-1030, or NIIN 010681030, (mounting pad,electrical-electronic component) was assigned November 16, 1978 in the Federal Logistics Information System (FLIS). NIIN 010681030 was cancelled on May 2, 2013, with a cancelled status of "Item is Cancelled - USE." This NSN was replaced by NSN 5999011992861. This NSN does not replace any other NSNs.
There are 2 manufacturer part numbers associated with this NSN. One of those part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 3 suppliers. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, there are no suppliers that are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Apr 01, 2020, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 61934. [AN ITEM FABRICATED FROM ELECTRICALLY NONCONDUCTIVE MATERIAL SPECIFICALLY DESIGNED TO PROVIDE A SUPPORT FOR MOUNTING AN ELECTRICAL AND/OR AN ELECTRONIC COMPONENT SUCH AS A SEMICONDUCTOR DEVICE, RELAY, OR RESISTOR INTO THE NEXT HIGHER ASSEMBLY. IT ISOLATES THE COMPONENT FROM THE MOUNTING SURFACE OF THE NEXT HIGHER ASSEMBLY, IT MAY ACT AS A STRAIN RELIEF TO AVOID DAMAGE TO THE COMPONENT SEAL, AND IT MAY PERMIT SOLDERING OF THE COMPONENT TO THE NEXT HIGHER ASSEMBLY WITHOUT DAMAGE. IT INCLUDES HOLES, NOTCHES, OR OTHER PROVISIONS FOR PHYSICAL ALIGNMENT AND SPACING OF ELECTRICAL LEADS AND/OR OTHER MOUNTING FACILITIES PROJECTING FROM THE COMPONENT IT MOUNTS. IT MAY ALSO AFFORD PROTECTION FROM SHOCK OR VIBRATION. IT MAY BE EITHER NONTHERMALLY CONDUCTIVE WHICH PROTECTS THE COMPONENT FROM TEMPERATURE CHANGES IN THE NEXT HIGHER ASSEMBLY OR IT MAY BE THERMALLY CONDUCTIVE WHICH PERMITS HEAT GENERATED IN THE COMPONENT TO BE DRAINED OUT TO A HEAT SINK. FOR ITEMS WHOSE FUNCTION IS ELECTRICAL INSULATION ONLY, SEE INSULATOR, (AS MODIFIED). EXCLUDES:HOLDER, (AS MODIFIED); RETAINER, (AS MODIFIED), AND SPACER, PLATE.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5999010681030 does not contain precious metals.
This information was last updated on Dec 01, 2024.